五月婷婷中文_总裁与秘书啪啪日常H_精品视频国产香蕉尹_亚洲图片日本视频免费_男女乱滛免费视频网站_藏经阁91福利私人试看_99久久国产综合精品一级_国产精品午夜福利电影_另类福利亚洲丝袜激情在线_免费在线观看最新理论片

Shengong vacuum -- Notes on disassembly and assembly of liquid ring vacuum pump

Addtime: 2020-07-18 Browse times: 1973

Liquid ring vacuum pumps and compressors are used to pump or compress air and other gases which are non corrosive, insoluble in water and do not contain solid particles, so as to form vacuum and pressure in closed containers. It is widely used in machinery, petrochemical, pharmaceutical, food, sugar industry and electronic fields. Liquid ring vacuum pump in the working process, gas compression is isothermal, so in the compression and suction of flammable, explosive gas, not easy to occur danger. Therefore, the application of corrosion-resistant submerged pump is more extensive. What points should be paid attention to when disassembling liquid ring vacuum pump?


The disassembly of the pump is divided into partial disassembly, inspection and cleaning, and complete disassembly, repair and replacement of parts. Before dismantling the pump, the water in the pump should be drained from the drain hole. All gaskets should be carefully removed during disassembly. If damaged, new gaskets with the same thickness should be replaced during assembly. The pump should be disassembled from the end without coupling in the following order.


1. Loosen and remove bearing cover.


2. Loosen the rolling bearing, screw off the round nut with hook wrench, and remove the nut on the packing gland.


3. Loosen the bearing frame from the side of the left side cover, and at the same time, turn the two removal screws (square head and cylindrical end screws) to remove the bearing and bearing bracket from the shaft.


4. Disconnect the water inlet pipe and pipe on the side cover, and loosen the connecting screw between the pump body and the side cover and the stud bolt outside the pump foot.


5. Add a cushion under the pump body, then make the side cover and the pump body away, and take down the side cover from the shaft (the shaft should be supported after the side cover is removed).


6. Make the pump body away from the cover on the other side and remove it from the shaft.


At this time, the working parts and parts of the pump can be inspected and cleaned. Further disassembly should be carried out in the following order.


7. Cut off the connection between the motor and the circuit, loosen the connection between the motor and the base, and separate it from the pump.


8. Remove the coupling from the shaft with a wrench and other disassembly tools.


9. Remove the key of the coupling from the shaft.


10. Remove the bearing cover. Remove the locating ring or round nut to loosen the rolling bearing.


Scan QR code and add wechat