Addtime: 2020-07-17 Browse times: 2009
With the development of mechanical modernization, the process of mechanical automation is faster and faster, and many enterprises are also carrying out technological innovation. For high-pressure roots vacuum pump, juedui has the right to speak in this respect. We employ foreign experienced technical personnel to conduct on-site guidance. After research, we found that in the effective process of expanding the application of high-pressure roots vacuum pump unit, we should pay attention to the production of high-pressure roots vacuum pump unit Product performance advantages, enhance its overall process of continuous promotion, according to the requirements of its various aspects of application, increase the application effect of the unit products, according to the actual situation, effectively promote the full play of its performance, increase the performance of product strength, make it more in line with the improvement of application performance in all aspects Further expand the performance of all aspects of the product.
High pressure roots vacuum pump has a great advantage, which can not be replaced by other pumps. When the high-pressure roots vacuum pump works at a low position, its pumping speed is very fast. However, it has a disadvantage that it can not be used independently. Another vacuum pump must be connected in series to use it. It uses the suction pressure of the vacuum pump in front of it to send it to roots vacuum pump. At this time, the high-pressure roots vacuum pump can not be replaced by other pumps Roots vacuum pump just started working. Under normal conditions, some protective measures should be installed when installing the front stage vacuum pump, otherwise the high-pressure roots vacuum pump will be damaged due to overheating. Therefore, protective measures must be added. So how to choose the front stage vacuum pump? When removing the steam gas, it is better to select the front stage positive air pump as far as possible. If it works under general conditions, it is necessary to select other vacuum pumps.
Usually high pressure roots vacuum pump in the suction of a lot of water vapor gas will appear this situation, oil seal simple problems. The conversion of water vapor from gas to water is an exothermic phenomenon. The high-pressure roots vacuum pump will generate heat, and the oil seal will show thermal expansion. At the moment, there is negative pressure in the pump and atmospheric pressure in the gearbox, and the water vapor will be pressed into the gearbox.
Scan QR code and add wechat